Search results

Re: Good article on barrel length I have really been wanting to chop my 26" 300wm down to 20 or 21, all this info is really pushing me down this path.

Re: Good article on barrel length <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: sakoluvr</div><div class="ubbcode-body">I only shoot the 180 Acubonds over H4831sc. Also came across this: From Rifleshootersmag, Sept/Oct 2003, .300 Win Mag, 180-grain bullets and...

Re: Good article on barrel length From: Guns magazine, by Clint Smith just found this last night. There is often a general belief that longer barrels are more accurate than barrels of a shorter configuration. Part of this thought may extend from the period when most rifles were equipped with...

Re: AICS stock cheek weld & mag question I had to use high rings, and they are borderline, but I have a high cheekbone.

I am wanting to shorten/thread my 300wm barrel. I only shoot factory ammo 180grn. maximum.( If I were to reload, it be to factory specs. no hot loads). Has anyone gone down this road to give some insight? I am thinking 20"~22", TacOps did one down to 22" with no loss in velocity shooting 190grn...

Re: Rem 700 bottom safety conversion? Anyone chime in on the left hand safety lever?

Re: Rem 700 bottom safety conversion? I was looking at it this morning , and also concerned about rear pull to disengage the safety. I need to submit more info on this topic: I am a lefty, so not only is it an awkward reach on the aics, it is on the wrong side. I am thinking either putting...

Re: Rem 700 bottom safety conversion? Have you ever seen it done, do you add onto the existing mechanism , or build a new linkage like on the jewell that comes with the botoom safety.

I just dropped my pre 2006 700 la into an aics 1.5. I am not liking the awkward reach to the safety, has anybody converted the factory trigger mechanism to a bottom safety as on the the jewell? Looks to be a simple lever change?