Search results
-
T
Looking for a good welding machine.
Re: Looking for a good welding machine. Both Lincoln and Miller are good names. I own a Millermatic 252 and could not be happier with it. If you go MIG my only suggestion is to get a larger machine then you think you will need. ARC is nice for less prep and cheaper setup cost, but for a...- Truno223
- Post #4
- Forum: The Bear Pit
-
T
DIY steel targets . . . continued
Re: DIY steel targets . . . continued I just whipped up two of these to try out this weekend. They're 2 foot tall by 18 across. I used 3/4 inch black pipe, the top bar is welded at the 90s whereas the verticals are lathered in anti-seize for easy removal. The chain is mounted to a piece...- Truno223
- Post #80
- Forum: The Armory
-
T
recomendations on case prep machine?
Re: recomendations on case prep machine? I've had good luck trimming with an RCBS and an electric drill. Primer pockets and chamfer/debur are handled on two drill presses. I processed about 150 cases in a little over an hour using these methods this past week. I just chuck a Lee...- Truno223
- Post #10
- Forum: Reloading Depot
-
T
Rifle Scopes Scope situation.
Re: Scope situation. I would get some better glass for the rifle. I have a cheapo Mueller Eraticator that I got from JoeBob's for about 200 bucks. My rifle is a 93R17BVSS that has the barrel cut to 16.5in with a target crown. I shot this group at 100 with the stock old style trigger, the...- Truno223
- Post #7
- Forum: Observation & Sighting Devices
-
T
Gunsmithing will this get around the atf rules legally ?
Re: will this get around the atf rules legally ? Just curious, how long has the FFL to <21 receiver law been around?- Truno223
- Post #78
- Forum: The Armory
