• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Search results

Search the forum Search Articles
  1. C

    Cleaning Case Lube Off Loaded Rounds

    Not sure if this will help in the OPs situation. I single stage. Pop primers, sonic, size. To get most of lube off cases before I trim... I use the leg off old sweat pants sewn up on one end. Drop in the cases and work them around. After trim, etc. then vibe with corn or walnut. Now they...
  2. C

    Whats your 77smk 2000mr load?

    Obviously this is not a recommendation. Only personal experience with one particular rifle. Rifle, AR 15, 20'' FN CHF barrel, 5.56 chamber. Can't say about 77 smk. Using 77 Nosler cc's. over 2000mr, LC brass, cci 41 primmer, max mag length in AR stoner mags 2.26+, BTO 1.8860. ETA; with...
  3. C

    removal of upside down primers

    I use a Lee universal decapping die. It's press mounted. For upside down primmer I just use slow steady pressure to push it out. I do use safety goggles, welder glove and stand back. Always a bit unnerving. :) I don't like the idea of tapping it out with pen and a mallet. Sounds too much like...
  4. C

    .308 Hand load issue, stovepipes

    It sure may be something else, but as NICETRY said give that suppressed setting a try and see what happens. I had similar problem, piston AR none adjustable gas, some stove pipes and brass just pooping out at 1 o'clock. Long story short, after much messing with bolt etc. H2 buffer and wolf...
  5. C

    .308 Hand load issue, stovepipes

    Do any of the ejected brass have a half moon shaped dint on side of case? This can be caused by brass slamming into back of ejection port, BCG traveling too fast, over gassed. Best caveman
  6. C

    Magnetospeed Bayo (V1) - Material loss from Muzzle blast

    I just noticed a little pitting also. Not as much as yours, but have less than 200 rounds over it. I've been using it on an AR, 223 with A2 FH. I love the thing. Hope it don't slowly disappear. :) I may give them a call tomorrow and see what they have to say. 512-284-8161 Best caveman
  7. C

    Lee Case Length Gauge

    I've had the same problem with .223 brass. I had to back out the gauge a bit from the cutter to get proper length. I think when I screwed in the gauge nice and tight, it bends the cutting edge that it bottoms out on. I got it to work but have to keep an eye on it. A Wilson is on way. Best...
Top Bottom
Back
Home
Forums
Merch
Alerts