Search results

Re: Is it normal for POI to shift? Your shoulder placement and tension often change when going from bench to prone. This can affect pressure on the bipod.

Re: Scratched up brass from rifle? On new ARs, I find 2 lines going down from the ogive to about halfway on the brass. This is from the feed ramp on the barrel. The first few rounds on a new mag may scrape the edge of the mag if you feed it slowly, but it is probably the feed ramp. This...

Re: Best Brass Cleaning Method ?? In my experience, using a cheap homemade ultrasonic solution will clean cruft from deeper places than a tumbler, it will not get everything. I end up tumbling after ultrasound anyway to polish away water spots (personal pref). The single fear I have of SS...

Re: looking for good 308 dies Redding dies are reasonable well priced and usually good. You will probably be fine with a F/L set. If you know anyone else near by, try theirs out as well, and take as many measurements as you can of fire formed brass vs post sizing to see what is happening to...

Re: Who still has their origional GA Remington Trigger If you need your trigger weight to go below 3.5 lbs reliably, then the Jewell is the way to go. Adjusting the stock Remington trigger can be hit or miss and over time, it may "adjust itself" which could be very problematic. But if you...

Re: October 2012 Las Vegas Precision Rifle results As a first timer at the match (or any match), I can say it was a great experience. I learned a great deal and the community of shooters was extremely helpful. Thanks again for setting it all up. Chris