Search results

BAT changed the position of the posts around SN 1050. Was Joe's VR lower or higher than 1050?

Looking for AICS AX Mk 2 with 13" foreend for 700SA in black, product code 26712BL or 26712EM. Must be New In Box or Like New In Box, complete with all original factory-supplied parts.

Is the Impact action Rem 700 SA compatible?

SOLD to 2tuf4u - thanks!

Thank you!

Great catch - thank you - a slip for sure. Listing is edited and is now correct.

Reticle - P4 Fine reticle illuminated Turrets - MIL double turn, counter-clockwise This scope is brand new and has never been mounted or used. its optics, coatings are pristine and mechanicals positive. It comes in the original factory box with the manual and hex key. Front and rear Butler...

PM Sent

still confirming some details.....

what are its dimensions?

Pat, I remembered you switched from Tula LRM to GM210M recently. Do the 210M (and 215M) fit the notoriously "generous" Rem primer pocket better than the Tula? What are the actual performance differences between these primers for the 6.5 GAP round, and what would be good alternatives as all three...

Not sure if what I can share can be called "advice" but here is what I have been able to gather: 1. The Armalite factory 300 SAUM "AR-10 (T) Ultra" uses proprietary parts made for the specific requirements of the AMU trials. Armalite will not sell these parts to anyone except owners who broke...

Please see attached chart. 2 series are shown with different COAL and Twist. Also added powder type and percent of powder burnt to second series. With the longer COAL and slower twist, 2 MV's stayed the same (but all used more powder). RL25 and Retumbo burning 100% of powder will probably leave...

Attached is a table showing some QL runs with the powders you named above. They are based on the following assumptions: 1. 24 in tube 2. 130 VLD Hunting Pointed, BC assumed to be 0.600 3. COAL 2.825 4. Case H2O 73gr 5. Pressure as close to 55kpsi without going over Sorry - did not know...

How about Ramshot Magnum, Accurate Magpro and IMR 7828SSC? They are all slower than 4831SC.

Thanks for your insights, CPGFAN. When you say "both of mine" in your reply, do you mean both of your rifles are GAP Xtreme Hunters in 6.5 SAUM 4S? My experience with ball powders in general and Magnum/MagPro in particular is that they are more susceptible to temperatures swings between July...

George, I know H1000 is de rigeur but - temperature sensitivity of ball powders notwithstanding - have you tested Ramshot Magnum or Accurate MagPro for use in the 4S? My QL runs show that keeping under 56kpsi Magnum matches H1000 and MagPro gives a tad more velocity than H1000. Just...

Thanks - that is exactly what I wanted to know. Looks like it's 2 grains more than 6.5G but 1 grain short of the fireformed T40i.

Thanks for the great thread and meticulous reporting! BTW, what's the measured water capacity of fireformed Lapua cases in your barrel? With virgin 6.5G Lapua cases, I'm right around 35.1 and 1x-fired Hornady at about 36.0.