Search results

Always wanted a 300 win mag for long range target so I built this . Kelby action , KRG chassis with enclosed forearm , Triggertech trigger . The barrel is a green mountain blank I turned to 10 mtu , chambered and threaded .

What action are you running ? I have a Solus chassis here and the recoil lug cut is shallow .

Well did it shoot better after they returned it ?

I thread all my 22 cal rifles 5/8-24 just to use some older direct thread 308 cans .

The PRC and Rum are two different cartridge lengths so if you using a adjustable stop on the throat reamer you will have to adjust for each .

Another way to remove that screw is to sacrifice the scope base , cut the base beside the screw pry up and the base will snap in two . Grab the head with some small visegrips and twist. We run into this with Savage rifles when we remove the two piece bases the screw heads are soft and strip easily .

This action has about three hundred rounds fired and doesn't show any wear .

Thank you !

Green Mountain still uses metal stamps on their barrels . The blank is only 1.06" diameter ? https://www.gmriflebarrel.com/round-rifle-barrel-blanks/gunsmith-edition-raw-barrel-blanks/25in-round-barrel-blanksEdit to add .....

Might sell my chemical etching setup really don't use it anymore .

Good shooting and great caliber !!

Looking at the Curtis Valor and the Terminus Zeus the barrel change feature looks the same ?

Looking to build a rifle in the same caliber ! If you see if offered can you update this thread ?

Hopefully they offer one for long action soon !

Thanks ! Getting ready to install a ten twist barrel this week and was second guessing my choice for heavier bullets.

What twist rate are you using with the 200+ grain bullets ?

Your right I should have said many of them come threaded 1/2-28 .

Funny thing is my grandsons 350 is 5/8-24, just the way I threaded it . I didn't say 1/2-28 threads were the way to go just making a point some factory guns come with 1/2-28 threads so the wall thickness must be safe.

All 350 Legends come threaded 1/2-28 and that's a .355 bore so I wouldn't think doing a 1/2-28 on a .243 would hurt anything other than not matching the adapters that come with bigger bore cans .

Your 350 legend should have a 1 in 16 twist if the upper is factory . We put ten twist barrels on our bolt guns and shoot factory subsonic ammo suppressed . I wish there was subsonic reloading data out there for cheap 9mm bullets.