Search results

G and g rifleworks is one hell of a company. Wouldn't hesitate to buy from them again.

Thanks Sinister, I appreciate your explainations. This thread has been informational and entertaining to say the least.

Is anyone using a "supported" bolt carrier group? For example the lantac enhanced BCG or CMC BCG with the larger flange at the end of the carrier that is supposed to aid in repeatability. Is this aiding in accuracy or is this market hype?

Thanks bfoosh006 good reads

Is anyone using a "supported" bolt carrier group? For example the lantac enhanced BCG or CMC BCG with the larger flange at the end of the carrier that is supposed to aid in repeatability. Is this aiding in accuracy or is this market hype?

Anybody know if the tango 6 1-6 sfp mil reticle suffers the same low illumination as the ffp model? A picture would be awesome. Hoping for a daylight bright response. But not holding my breath.

Sorry I haven t replied lately. I 've been busy with a new born. I guess that was my question was if I could be stable enough. I can send a decent shot down range in other than prone but it's much more difficult to get a good mill while managing my wobble.

Sorry I haven't replied to anyone thus far. Work has been a black hole for me lately. I probably should have refined my question a little more but banshee sws answered it well. Thanks guys.

I understand milling and in the classes I have taken we are always in prone position while doing so. Does anyone ever practice milling outside a prone position. I understand it will not be as accurate but could it be used to ballpark it, or am I just wasting my time. I understand laser range...