Search results

Do you have a suppressor, adjustable gas block, heavy buffer, or any other tuning on your rifle?

I would expect StaBall to work. Try it, and post your results.

I tried to PM you but couldn’t.

PM sent

Same rifle, bullet, basically same primer, and case. The difference is Varget on the right and 4166 on the left.

I’ve been reloading a long time for many rifles and cartridges. I’ve got a jug of IMR 4166 I’m trying to burn up in 308. Has anyone had luck with any combination they feel like sharing?

Today, I went to the range to see if I could find a primer that will work with an AI that has a larger firing pin. The primers tested left to right were Winchester #41, Winchester SR, Federal 205, CCI 450, CCI BR-4, and Remington 7.5 BR. The load for each is 28.3 of IMR 4166, Norma brass, and...

I’ll take this.

I have loaded a lot of it for 223 Palma. It’s a fantastic powder.

I’ll take these.

How many?

What is the length of the mag from back to front?

Does anyone know the length for a minimum SAAMI headspace? Thank you.

I like 44.4 of Varget with a 169. I use Lapua and a CCI 200 or BR2.

Excellent snag

I’ll take this for $240

I have loaded many 100s of thousands of rounds. I cannot tell a difference, on steel or on paper, between the rounds loaded on my Lee, RCBS, Hornady, or Dillon presses (using the progressives as singles). There is nothing wrong with your Rockchucker. Stick with that.

I’ll take it.

My 6br rifles are slow. I’m getting 2,600-2,700 fps depending on bullet and barrel length. I get pressure signs if I go for top speeds. I get pierced primers in the AI. The primer jams up the firing pin.

I like S&W revolvers for pocket carry as well. You can fire a revolver from a pocket if needed. The P7 mentioned above is WAY too heavy for pocket carry.