expander
-
WTB Looking for SAC .3065 Expander Mandrel
Hey all - looking for Short Action Customs expander mandrel in 0.3065" This is for my 300 PRC sizing die. They are out of stock right now and can't say when to expect them back, so of course I need one! Let me know if you have an extra! Thanks.- mccarthy
- Thread
- mandrel sac short action customs sizing die
- Replies: 0
- Forum: Buy - Sell - Trade
-
Reloading Equipment WTB 21st century .242 and .2425 mandrels
Wanting to buy some expander mandrels .2420 and .2425 let me know wat you have you can send pics to 931310132five thanks in advance- 6.5guys2
- Thread
- .242 .2425 21st 21st century mandrel
- Replies: 4
- Forum: Buy - Sell - Trade
-
J
Expanding case mouth with Lee FL die after priming
So I bought some new brass online and got it all primed up and ready to load and the first bullet I went to seat got cut up pretty good. Upon further inspection, the case mouth I.D. was reading 0.220 or 0.221. I ran one of my once fired cases through my full length sizing die and took a...- jcmaxwell
- Thread
- 223 brass bullet seating lee neck tension reloading brass
- Replies: 2
- Forum: Reloading Depot
-
Reloading Equipment SOLD
21st Century Free Floating Expander Die With Ring Comes with the following 6mm mandrels: .2405 .241 .2415 .242 Used for about 200 pieces of brass. $55 shipped No trades- skulldragr17
- Thread
- 21st century 6mm die mandrel
- Replies: 2
- Forum: Buy - Sell - Trade
-
R
Expander ball on a neck sizing die?
I noticed that my Redding neck sizing die came with the expander ball on the decapping rod. Do you guys run the ball through after neck sizing? Seems counter productive to me. Especially when using a sized neck bushing. But, on the flip side I can see how it would provide more consistent...- Redhook
- Thread
- ball die neck sizing
- Replies: 3
- Forum: Reloading Depot
