Rifle Scopes 100 Yard Zero Issue

[emsp]

Setup:
Barrett MRAD
S&B PMII 5-25x56
Barrett 20/30 Zero Gap Rings (set to 20 MOA)

Issue:
As shown in the pictures I am way high at 50 and 100 yards. My index finger is the POA on each respective target. I am at the bottom of the travel of the scope. I would like to have a 100 yard zero and with my current set up that wont happen. My question is the rings to change out to remedy the problem?

SN: I could set a 500 yard zero but there is only one place to shoot 500 yards max in my area and finding a (legal) spot to shoot past that is difficult to find without driving at least 4 hours away.

 

[billyburl2]

Are you sure the zero-stop is allowing you to dial down all the way?

 

[wareagle700]

Looks like you need a standard (no cant) set of rings.
If I understand correctly, the slope of the top rail of the MRAD is 30 MOA, your rings having 20 MOA for a total of 50 MOA of cant. That seems like too much.

 

[bodywerks]

Yes that is way too much. Ditch the rings

 

[emsp]

new rings it is then, thanks gents

 

[sib1948]

You need Barrett ultra high Zero Gap rings in 34mm, since if I remember right that S&B has 34mm tube and 56mm objective. What I use for my March FX 5-40 with same dimensions. Perfect!!!

 

[tfont48]

I agree in saying to ditch the rings but I use larue tactical rings on my S&b 5-25x56 pmii and I have never been more satisfied.