I was wondering if it would be possible to mill a 20 moa slope into the extended savage scope base? Or ad a shim and bed the base with JB weld? Or just write it of as an air-soft accessory?
20 moa milled into savage TRR ninja base?
- Thread starter bark-eater
- Start date
Re: 20 moa milled into savage TRR ninja base?
Shim and bed would be the easiest method but if you have a Mill and the know how you could mill it yourself . My pard milled my base for me but he did a whole bunch of guys all at once since it was an hour to set it up and another hour to get his mill put back to zero when he was done . If you figure the average machine shop hourly rate is 60-80 dollars an hour your looking at a lot of ching just for setup and teardown time
Shim and bed would be the easiest method but if you have a Mill and the know how you could mill it yourself . My pard milled my base for me but he did a whole bunch of guys all at once since it was an hour to set it up and another hour to get his mill put back to zero when he was done . If you figure the average machine shop hourly rate is 60-80 dollars an hour your looking at a lot of ching just for setup and teardown time
Similar threads
