I have some 2nd fired brass that I'm getting ready to reload. I'd like to trim all of my case necks so they are the same. I can't seem to find what the minimum neck length is. I don't want to trim them too short. Any help?
300 winmag minimum case neck length
- Thread starter Jig Stick
- Start date
Re: 300 winmag minimum case neck length
Don't trim them at all until your bolt is hard to close. Every extra bit of neck length helps with this case.
I would not worry about uniforming length. Wait and determine your chamber's oal dimension and then trim only a minimum.
Don't trim them at all until your bolt is hard to close. Every extra bit of neck length helps with this case.
I would not worry about uniforming length. Wait and determine your chamber's oal dimension and then trim only a minimum.
Re: 300 winmag minimum case neck length
2.620" max, 2.610" min.
You need to buy a reloading manual.
2.620" max, 2.610" min.
You need to buy a reloading manual.
