6 Dasher Brass trimming

[CV_Ag]

What’s everyone using to trim dasher brass....that’s not a Giraud. I’m building a new rifle and coming from a 6.5CM. Debating on dasher and I’m pricing components etc with what I already have. Current trimmer is a trim-it II which they’d have to make a custom shell holder for a dasher. Just curious what everyone else is using.

 

[Sheldon N]

I used a LE Wilson trimmer after fire forming, used a power drill adapter and it wasn't too bad. I used a Giraud for the second trimming (after 12 firings).

 

[spife7980]

I used a LE Wilson trimmer after fire forming, used a power drill adapter and it wasn't too bad. I used a Giraud for the second trimming (after 12 firings).

Chamfer & deburr independently, right? There’s no three way cutter that exists?

 

[CV_Ag]

Chamfer & deburr independently, right? There’s no three way cutter that exists?

Yes, this^

 

[Sheldon N]

I would run the brass through a Lyman case prep center every loading for a quick champfer/deburr. Pretty much never needed to trim.

 

[Banango]

Following. Just got a dasher and thinking about a better trimmer than the hornady

 

[Triggs75]

I normally use a Forster case trimmer with their power adapter and put on their try way cutter.

 

[Triggs75]

Henderson Trimmer with the new motor = badass

I saw that on their site. Does the motor come with it or buy separate?

 

[Triggs75]

Oh wow $300 for the motor, yes that is pricey. I was thinking it would be about another $100 for the motor. But you do get what you pay for so am sure it is quality.