• Watch Out for Scammers!

    We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!

SOLD A bit of 6mm ARC stuff!

erikc641

Private
Supporter
Full Member
Minuteman
Apr 9, 2017
727
35
Las Cruces, NM
So, I am getting out of 6mm ARC. I have too many other projects going and lost interest. The barrel shot well (sub moa) but just have too much going on as I said.

Barrel- $185 shipped

Premium Series 20" Ballistic Advantage DMR profile 6mm ARC
7 twist, .750 gas block (rifle length)
416R SS
Nickel Boron M4 feed ramp extension
threaded 5/8-24
**Factory ammo fed fine at factory length. Did not have to shorten it as been reported by other 6 arc users

BCG-$90 shipped

PSA Nitride Bolt Carrier Group
9310 bolt, 8620 carrier
Properly staked, grade 8 fasteners

Dies- $50 shipped

Hornady FL set (sizer and seater) with Lee FCD, shell holder and Hornady modified case.

Bullets-$80 shipped

Nosler 6mm 105 RDF
2 boxes (1 full but opened) and the other has 85

Brass-I couldn't get any new brass at the time so all of it started from factory ammo (either black or match) $150 shipped

Hornady, 200 pieces. I would say the vast majority (80+% are 1x fired). I didn't do a lot of handloading, just shooting factory ammo to get brass and then never got around to using any of it.
Annealed, tumbled, sized, trimmed, chamfer/debur and primed with a CCI 450
11 pieces 2x fired and unprocessed (spent primer in place)

Ammo-SOLD

78 count 108 grain ELD M (2 full boxes, 40 rounds, are same lot #)
49 count 105 BTHP (Black) all are same lot #

SOLD


Target pictured is the only documented handloading session I have with the 105 RDF and one test load with the 70 grain Varmageddon. All shot from 100 yards, magazine fed and from prone using a bipod. The Varmageddon load chronographed at 3,096 ft/s and the others hovered around 2600 ft/s. All were shot with LeveRevolution powder. Everything is in very good condition and barrel was never shot rapidly. I will include a 5/8-24 thread protector that was on my RPR to protect it during shipment. With 211 pieces of brass and the 15 handload shots, I am estimating round count to be 226 rounds down the tube. Bore is bright and well taken care of and rifling is still sharp.

All prices OBO. Any questions, ask away!
 

Attachments

  • thumbnail_IMG_6629.jpg
    thumbnail_IMG_6629.jpg
    268.7 KB · Views: 112
  • thumbnail_IMG_6627.jpg
    thumbnail_IMG_6627.jpg
    131.2 KB · Views: 74
  • thumbnail_IMG_6626.jpg
    thumbnail_IMG_6626.jpg
    267.3 KB · Views: 71
  • thumbnail_IMG_6625.jpg
    thumbnail_IMG_6625.jpg
    489.8 KB · Views: 68
  • thumbnail_IMG_6624.jpg
    thumbnail_IMG_6624.jpg
    463.8 KB · Views: 62
  • thumbnail_IMG_6622.jpg
    thumbnail_IMG_6622.jpg
    174.9 KB · Views: 66
  • thumbnail_IMG_6621.jpg
    thumbnail_IMG_6621.jpg
    311.1 KB · Views: 69
  • thumbnail_IMG_6620.jpg
    thumbnail_IMG_6620.jpg
    344.3 KB · Views: 72
  • thumbnail_IMG_6619.jpg
    thumbnail_IMG_6619.jpg
    265.4 KB · Views: 77
  • thumbnail_IMG_6618.jpg
    thumbnail_IMG_6618.jpg
    293 KB · Views: 106
  • 168663197_932752057477532_7249471116676428547_n.jpg
    168663197_932752057477532_7249471116676428547_n.jpg
    82.2 KB · Views: 108
Last edited:
So, I am getting out of 6mm ARC. I have too many other projects going and lost interest. The barrel shot well (sub moa) but just have too much going on as I said.

Barrel-

Premium Series 20" Ballistic Advantage DMR profile 6mm ARC
7 twist, .750 gas block (rifle length)
416R SS
Nickel Boron M4 feed ramp extension
threaded 5/8-24

BCG-

PSA Nitride Bolt Carrier Group
9310 bolt, 8620 carrier
Properly staked, grade 8 fasteners

Dies-

Hornady FL set (sizer and seater) with Lee FCD, shell holder and Hornady modified case.

Bullets-

Nosler 6mm 105 RDF
2 boxes (1 full but opened) and the other has 85

Brass-I couldn't get any new brass at the time so all of it started from factory ammo (either black or match)

Hornady, 200 pieces. I would say the vast majority (80+% are 1x fired). I didn't do a lot of handloading, just shooting factory ammo to get brass and then never got around to using any of it.
Annealed, tumbled, sized, trimmed, chamfer/debur and primed with a CCI 450
11 pieces 2x fired and unprocessed (spent primer in place)

Ammo-

78 count 108 grain ELD M (2 full boxes, 40 rounds, are same lot #)
49 count 105 BTHP (Black) all are same lot #

Target pictured is the only documented handloading session I have with the 105 RDF and one test load with the 70 grain Varmageddon. All shot from 100 yards, magazine fed and from prone using a bipod. The Varmageddon load chronographed at 3,096 ft/s and the others hovered around 2600 ft/s. All were shot with LeveRevolution powder. Everything is in very good condition and barrel was never shot rapidly. I will include a 5/8-24 thread protector that was on my RPR to protect it during shipment. With 211 pieces of brass and the 15 handload shots, I am estimating round count to be 226 rounds down the tube. Bore is bright and well taken care of and rifling is still sharp.

Asking $700 shipped OBO for all of it OBO. Any questions, ask away!
Pm Sent
 
All sold. I tried to reply to everyone even if you missed out. If I didn’t, I’m sorry. There were a lot of inquiries. Thank yoy