I just finished setting up my NFA Trust and plan on purchasing the AAC Titan SS. I want to use it on my Rem 700 5r .300 wm. I have a NF 5.5-22x50 mounted with a NF 20 MOA base and NF low rings. The titan is listed having a diameter of 1.85. Will I have enough clearance so that the suppressor does not block my sight picture through my scope? I am afraid that I may need to get the medium or high rings.
Suppressors AAC Titan question
- Thread starter gamhuntr
- Start date
Re: AAC Titan question
I don't know about your setup but with mine it was annoying with low rings because I could see my tab cover in the bottom of my scope... I was running a r700 28in Kreiger 300 wm with 20min badger base and a razor in low IOR rings...I did buy an aadmount which is stupid high for my application but I don't notice it anymore though this won't be a permanent solution... Also the suppressor is a AWC thundertrap which might have a smaller od than the the titan not sure though...but I run an aics so I just adjust the cheek piece up and just use it for now
I don't know about your setup but with mine it was annoying with low rings because I could see my tab cover in the bottom of my scope... I was running a r700 28in Kreiger 300 wm with 20min badger base and a razor in low IOR rings...I did buy an aadmount which is stupid high for my application but I don't notice it anymore though this won't be a permanent solution... Also the suppressor is a AWC thundertrap which might have a smaller od than the the titan not sure though...but I run an aics so I just adjust the cheek piece up and just use it for now
Re: AAC Titan question
On low power, you might see it in the bottom of your scope....
At high mag it will disappear.
On low power, you might see it in the bottom of your scope....
At high mag it will disappear.
