Gunsmithing Allen wrench size for Jewell Trigger??

[johncamino]

Does anyone know what size allen wrench I need to adjust the trigger pull on Jewell?? My smallest wrench is too big, its ashamed they don't include one with the trigger since its so small.

thanks,
John

 

[Rhys]

Re: Allen wrench size for Jewell Trigger??

I think it's .050, but will have to check.

Just checked and .050 is correct.

 

[johncamino]

Re: Allen wrench size for Jewell Trigger??

thanks, I'm running to harbor freight to pick one up!

 

[AXEMAN]

Re: Allen wrench size for Jewell Trigger??

just a thought. i shop at harbor freight. but swing by a hobby shop and get a nice ball end allen for this. not that HF wont work. i have that size in my set from them, but sometimes their steel isnt the best. its not like your gonna adjust it alot, so it may be fine. but you will have to buy a whole set. the hobby shop has nice driver sets and singles of a higher quality. like i said, just a thought...

 

[wadebrown]

Re: Allen wrench size for Jewell Trigger??

I buy my small allen wrenches from the hardware store in the drawers where they stock set screws. The small set screws have use small allen wrenches and they usually have them in the same box/drawer.

I go there as it is easier to find them and they are not as expensive as the individual wrapped special small size wrenches on the wall selections.

wade

 

[Oldoggie]

Does anyone know what size allen wrench I need to adjust the trigger pull on Jewell?? My smallest wrench is too big, its ashamed they don't include one with the trigger since its so small.

thanks,
John

Yes I am floored by the fact that I spent the money on the Jewel trigger and it doesn’t include a Allen wrench or the size of the wrench. Come on guys.