I got a new amp mate and annealer. the set up seemed pretty straight forward. All works as it should but when the case is pulled up and is being ejected the mate is trying to load the next case and it just falls off since the shell holder is no where near. I tried changing the servo arrangement but nothing I have tried has worked. Any body have some good insight on this??? I have not been able to find anything on you tube..
AMP Mate setup issues...
- Thread starter Pahighlander
- Start date
Does the eject arm hit the little spring touch and depress fully the limit switch? You should feel it click if you move the spring with your finger. If the eject arm isn’t fully depressing it bend the limit switch a tiny amount so it does.
