Rifle Scopes ARC M10 QD mounts

[Simia Dei]

I'm sure this has been done to death but I can't find the info. I'm chasing some guidance on QD scope mounts, I'm looking at the ARC M10 QD mount to use to bounce a scope between two rifles in the interim whilst I wait for a second optic. My questions are:

- Does anyone have any experience on return to zero with this (or similar) mount?

- Are there any better options? (I'm in Aus so suggestions may be a challenge to find, the 20MOA QD Spuhr mount doesn't look like it's available here yet)

It'll be used on a 5-25x PMII, so will I also have any issues with the low vs the high mount? (Rifles to bounce between are a Bergara HMR and a custom with a Stiller + 30MOA rail / MTU barrel).


TIA

 

[diverdon]

If you are willing to use your coldbore shot to verify your zero, you should be ok.

 

[Wyzrd]

Every time I took off my scope in the M10 QD-L mount and put it back on, my shots were usually within a half inch of my original zero, never more than an inch. Definitely one of my favorite mounts!

 

[Conrad]

The QDL has an Allen head that resides inside of the knob you see, so this allows you to torque to same spec every time making them extremely repeatable. ARC mounts are excellent.

 

[Simia Dei]

Thanks fellas, I'll be ordering one as soon as they're in stock here. I just need to determine whether I can get away with a low mount or if I will require a high one.

 

[TheOE800]

Thanks fellas, I'll be ordering one as soon as they're in stock here. I just need to determine whether I can get away with a low mount or if I will require a high one.

www.mil-rad.com

 

[Simia Dei]

www.mil-rad.com

Thanks mate, that's magic and answered my question.

 

[Daniel33]

The ARC M10 QD-L SCOPE MOUNT utilizes thumb screws to tighten the mount to the rail. Are these thumb screws difficult to toight with arthritic fingers ?

 

[b6graham]

The ARC M10 QD-L SCOPE MOUNT utilizes thumb screws to tighten the mount to the rail. Are these thumb screws difficult to toight with arthritic fingers ?

there's an allen inside to use for torque

 

[Daniel33]

there's an allen inside to use for torque

Ok, great, thank you !

 

[PBWalsh]

Can anyone comment on how these perform/return to zero compared to a QD SPUHR or Giessele Super Precision Mount?

Thanks