Just got a new build in today 700 in a T5 with mini chassis Badger M5 DBM, I cannot cycle the bolt with a empty magazine it sets to high and catches the bottom edge of the bolt. Do I need to adjust the mag?
Badger m5 and ai question
- Thread starter CSiebert
- Start date
Re: Badger m5 and ai question
You cant cycle it at all? Or does it have heavy resistance? My HS that had a badger in it was very stiff until I took some 600 grit wet sand paper to the magazine lips. If your bolt wont move past the mag at all then I'd give manners or whoever did your build a call.
You cant cycle it at all? Or does it have heavy resistance? My HS that had a badger in it was very stiff until I took some 600 grit wet sand paper to the magazine lips. If your bolt wont move past the mag at all then I'd give manners or whoever did your build a call.
Re: Badger m5 and ai question
No the follower is just a little to high and it catches the bottom edge of the bolt when the mag is empty. I am gonna bevel the egde of the follower so the bolt can jump over it.
No the follower is just a little to high and it catches the bottom edge of the bolt when the mag is empty. I am gonna bevel the egde of the follower so the bolt can jump over it.
Similar threads
