I bedded my A5 and I made the bedding a little to thick. Now my DBM will not feed properly. Is there an easy way to remove the bedding and start over? Or should I send it to a smith and have them redo the job? Or just have the DBM inleted a little deeper?
Gunsmithing Bedding question
- Thread starter Jrb572
- Start date
Re: Bedding question
Just dig out the bedding with a dremel and do it again. Practice makes perfect.
Just dig out the bedding with a dremel and do it again. Practice makes perfect.
Re: Bedding question
you might be able to braze a little piece of tool steel on your mag catch to hold your mags up a little higher. That's what i did on mine.
you might be able to braze a little piece of tool steel on your mag catch to hold your mags up a little higher. That's what i did on mine.
