Gunsmithing Bedding scope base
- Thread starter jsthntn247
- Start date
Check out this video form LoneWolfUSMC 8541 Tactical.
http://www.youtube.com/watch?v=aoW5bHQqgis&list=SPABEFDD83DF9BA2A4
I applied bedding material to both the front and rear and then tightened the front but just used the rear screws as guides for the rear of the base, but did not tighten them. That would have defeated the reason for bedding the base.
Hope this helps.
http://www.youtube.com/watch?v=aoW5bHQqgis&list=SPABEFDD83DF9BA2A4
I applied bedding material to both the front and rear and then tightened the front but just used the rear screws as guides for the rear of the base, but did not tighten them. That would have defeated the reason for bedding the base.
Hope this helps.
like anything else, there are many ways to do it. i bed front and back at the same time. some prep work can let you know what you need. tighten the front of the base only and see if that raises the back of the action, repeat for the back screws. then you know if you need to only tighten one end or the other.
