Rifle Scopes Best interface and mount combo to piggyback a T1 on a SPUHR?
- Thread starter thefitter
- Start date
SPUHR A-0025 That is to mount a T1 offset on Spuhr rings. Not quite sure if that is what you are looking for.
That looks like it screws directly to the T1 with no other mount between the interface and the T1, right? If so that's exactly what I was looking for.
I will order the T1 without any mount, and just use this.
The MHS site is easier than the SPUHR site.
Thanks
Yes, it has 2 screws that attach it to the Spuhr scope mount at a 45 degree angle and 4 screws that attach directly to the T1 with no T1 mount.
I think it depends on where you wanna mount it.
And that depends on what kind of gun it is.
To my long range 6,5 rifle (Tikka T3) I have mounted it 12 o'clock
I really like that postition for that kind of rifle and I can easaly reach the T1 regardless of shooting from prone or any other position.
Here is the T1 best mounted with an A-0003 picatinny rail.
For some really big scopes like I have a 6-24x72 on my TRG 338 i prefer the half past one position as the scope is so big that my neck not can reach the aimpoint if i mounted it 12 o'clock.
Here is the T1 mounted with either picatinny rail A-0003 or T1 interface A-0025
For the AR where I only use the T1 to shoot fast at short distances i prefer the 5 o'clock position as I then can maintain my checkweld when rotating the gun.
Here is the aimpoint mounted with T1 interface A-0025
And that depends on what kind of gun it is.
To my long range 6,5 rifle (Tikka T3) I have mounted it 12 o'clock
I really like that postition for that kind of rifle and I can easaly reach the T1 regardless of shooting from prone or any other position.
Here is the T1 best mounted with an A-0003 picatinny rail.
For some really big scopes like I have a 6-24x72 on my TRG 338 i prefer the half past one position as the scope is so big that my neck not can reach the aimpoint if i mounted it 12 o'clock.
Here is the T1 mounted with either picatinny rail A-0003 or T1 interface A-0025
For the AR where I only use the T1 to shoot fast at short distances i prefer the 5 o'clock position as I then can maintain my checkweld when rotating the gun.
Here is the aimpoint mounted with T1 interface A-0025
Similar threads
