i am looking for a 1 1/2 in tube for a suppressor. being that its a 338 lapua i should use 3/16in walls and 12inched long. i am looking for seamless stainless or if i can find affordable titanium i would conciders. please let me know if you know where i can get this without braking the bank...
Suppressors building a suppressor need a tube for it
- Thread starter tjonh2001
- Start date
Re: building a suppressor need a tube for it
Have you checked www.onlinemetals.com , they're usually a good source for such things.
Have you checked www.onlinemetals.com , they're usually a good source for such things.
Re: building a suppressor need a tube for it
too small of a tube for 338 Lapua.....Just my opinion!!
I would find some 1.75 minimum
too small of a tube for 338 Lapua.....Just my opinion!!
I would find some 1.75 minimum
Re: building a suppressor need a tube for it
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: 737SHARK</div><div class="ubbcode-body">too small of a tube for 338 Lapua.....Just my opinion!!
I would find some 1.75 minimum </div></div>
And I would listen to this guy.
Hey David, how things going since you visited Thunder Valley here in Ohio? Looks like Im going to be spending a bunch of time out in Lewisville starting in Jan. I will have to swing by sometime.
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: 737SHARK</div><div class="ubbcode-body">too small of a tube for 338 Lapua.....Just my opinion!!
I would find some 1.75 minimum </div></div>
And I would listen to this guy.
Re: building a suppressor need a tube for it
How did you pick those dimensions? Before you pick something I'd suggest you quantify the design a little bit to make sure it's going to do what you want.
Then, I'd point you in the direction of the high end race car community. Large diam SS or Ti thin walled DOM tubing.
How did you pick those dimensions? Before you pick something I'd suggest you quantify the design a little bit to make sure it's going to do what you want.
Then, I'd point you in the direction of the high end race car community. Large diam SS or Ti thin walled DOM tubing.
Re: building a suppressor need a tube for it
I used .095" 4130 from online metals for my 338 rum can. It is 1.75" by 12" and covers the last 4 inches of the barrel. It weighs 3 pounds which is kind of heavy. I think yours would weigh about 5 pounds if using the 3/16" tubing.
Ranb
I used .095" 4130 from online metals for my 338 rum can. It is 1.75" by 12" and covers the last 4 inches of the barrel. It weighs 3 pounds which is kind of heavy. I think yours would weigh about 5 pounds if using the 3/16" tubing.
Ranb
Re: building a suppressor need a tube for it
You need to speak with these folks...
http://www.silencertalk.com/forum/viewforum.php?f=10
In addition, check the specs of known suppressor makers - AAC, Gemtech, Ops Inc, etc.
You need to speak with these folks...
http://www.silencertalk.com/forum/viewforum.php?f=10
In addition, check the specs of known suppressor makers - AAC, Gemtech, Ops Inc, etc.
Similar threads
