Rifle Scopes Busnell DMR scope resetting the zero stop

[rundm]

Can someone point me in the direction of how to reset the zero stop on a bushnell dmr scope back to factory? I have seen several vids on how to set the zero stop but not how to remove the zero stop. Thanks in advance, RG

 

[Spblademaker]

You could remove the turret. Loosen the three Allen screws on the zero stop. Replace the turret. Crank elevation all the way down. Then remove the turret and tighten the screws. Or you can just leave the Allen screws a little loose, so the zero stop just spins freely. And you can reset it again whenever you like.

 

[spife7980]

Just not tightening it will prevent the zero stop from being tightened...

Did you stop to think about what youre asking?