Cadex Chassis Ring Size Question

[Cat64]

Hi there. I am currently building a 30 Nosler with a Long Horn TL3 action, a 1’’ wide 29’’ barrel and would like to sit it in a Cadex Field Competition chassis. I am wondering what size rings do I need to get. Scope is the 34 mm Vortex Razor Gen II. Thanks

 

[kRcu]

1.35”-1.5” depending on preference.

 

[Cat64]

Thanks. I like my scope as close to the barrel/chassis as possible. Anyway, lower than 1.35’’ I guess would not go right? I see regular sizes are 1:26’’ and next size up is 1:45’’

Appreciate it

Cat

 

[kRcu]

1.26 May work, but doubt caps would fit. My FIL runs a Razor Gen 2 on his AIAX flat top and the 1.35” Spuhr is nice and low, but he can’t use a flip cap on the objective.

 

[TangoFiveSix]

I’ve got a Cadex competition right now. You’ll essentially need to treat your rifle like it’s got a full flat-top rail and use whateve rings clear that surface. I use a Cadex 1.5” one-piece mount to get enough height for my S&B 5-25.

 

[MOUNTIC]

1.42 ARCs would do the trick also.

 

[Deadman Pointers]

I run the Spuhr 4602, and I have 20moa on the Cadex chassis as well with the Gen2 Razor. Works great, more than enough adjustment on the scope out to 1k+, and the Aadmount scope covers fit fine.