Can someone post pictures or at least explain the inletting required for the receiver and stock in order to use CDI bottom metal on a FN SPR A5 rifle.
CDI Inlettng
- Thread starter tbugher62
- Start date
Re: CDI Inlettng
or you could just ask Jeff. or goto his site even
http://www.cdiprecisiongunworks.com/winchester_short_action__fn-spr.html
or you could just ask Jeff. or goto his site even
http://www.cdiprecisiongunworks.com/winchester_short_action__fn-spr.html
Re: CDI Inlettng
+1 for Jeff. Send the rifle to him, he does a great job and fast turnaround time too.
Flyingbullseye
+1 for Jeff. Send the rifle to him, he does a great job and fast turnaround time too.
Flyingbullseye
Re: CDI Inlettng
My stock did not need modifying. Bottom of the action needed the corners under the feed ramp "opened up" just a tad. Easy enough with a dremel.
C.Dixon has a thread in the gunsmithing section about modifying the mag instead of the action. If I do another FN I will modify the Mag.
My stock did not need modifying. Bottom of the action needed the corners under the feed ramp "opened up" just a tad. Easy enough with a dremel.
C.Dixon has a thread in the gunsmithing section about modifying the mag instead of the action. If I do another FN I will modify the Mag.
Similar threads
