CZ Mr. Fly in Manners VPT?

[hitman44]

Went to install the MR. Fly trigger in my 455 VPT and found out it wont fit the Manners inlet? Anyone else have this problem?

 

[45cal4life]

Common issue with the fly triggers. Just need to lengthen the trigger area. I'm not familiar with the Manners, might be able to use a dremel

 

[shaun1826]

Correct, it won’t fit without some inletting. I used a dremel and just went slow. I think I found a youtube video on it somewhere.

 

[hitman44]

Just with the Manners or all 455s?

 

[45cal4life]

Should be any stock with factory inletting. Djdillondon had to enlarge the trigger area of a Bodys tacticool and I sent a chassis back to MPA to have it enlarged. Fly trigger and I believe a Timney require additional inletting

 

[hitman44]

Weird, I watched the youtube video on the Timney and they just dropped it in.

 

[45cal4life]

I could be wrong on the Timney. Thought I read on here they required it

 

[nelson4147]

Looking at the fly trigger on cz's store page it says fits cz 455 with serial# greater then A956497. I have a VPT with serial# starting with C and have a Bscar trigger arriving soon. I hope it drops right in.

 

[fjr05]

Nelson 4147
the trigger fits the CZ455 ACTIONS greater than ser #... you may still have to inlet the stock a little bit to clearance the trigger housing.

 

[nelson4147]

Nelson 4147
the trigger fits the CZ455 ACTIONS greater than ser #... you may still have to inlet the stock a little bit to clearance the trigger housing.

Your probably right. I couldn't find anything where the inlett was changed to accept the fly trigger.