Had some fail to fires that would fire on the 3rd try like I wasnt seating them deep enough.
This was in my 6.5grendel. Never used these primers before.
This was in my 6.5grendel. Never used these primers before.
Do federal match ar primers have to be seated hard
- Thread starter LC 6.5 Shooter
- Start date
If you are used to using Win primers you may find these a bit tighter to seat.
I was suffering lots of the Win blow by in FGMM brass.
CCI and Fed primers must have a bigger OD as the problem went away when I switched.
I'll only use Win in mil cases that were crimped.
I was suffering lots of the Win blow by in FGMM brass.
CCI and Fed primers must have a bigger OD as the problem went away when I switched.
I'll only use Win in mil cases that were crimped.
I've always used "flush or further" as the seating criteria. After seating the primer, I set the round on a flat surface and see if the round "wobbles". If not ... good to go. I use both CCI and Federal Match, and haven't had a primer misfire yet.
