Eagle Claw Bi-Pod

[jawa]

Ok so I have a Harris 6"-9" Bipod w/o the leg notches. I wanted to make some eagle claws out of an old circular saw blade. Well, after pulling the pin out of the rubber knob on the bottom of one of the legs I realized I wanted to see if any of you knew where to purchase the eagle claws at...I had to spend about 45 minutes taking the whole leg apart to get the spring reattached inside.

 

[brand692]

Re: Eagle Claw Bi-Pod

I'm not sure what you are wanting to purchase...

The pin?
The rubber foot?
Or the Claw foot?

 

[jawa]

Re: Eagle Claw Bi-Pod

Im sorry, I am looking for the Claw foot...

 

[rweldon]

Re: Eagle Claw Bi-Pod

Try Triad Tactical.

 

[brand692]

Re: Eagle Claw Bi-Pod

Yup. Triad has them.

If I were you, I'd put a WTB add up in the WTB section. I've picked up three sets of them there over the last few months.

 

[phideaux]

Re: Eagle Claw Bi-Pod

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: jawa</div><div class="ubbcode-body">Ok so I have a Harris 6"-9" Bipod w/o the leg notches. I wanted to make some eagle claws out of an old circular saw blade. Well, after pulling the pin out of the rubber knob on the bottom of one of the legs I realized I wanted to see if any of you knew where to purchase the eagle claws at...I had to spend about 45 minutes taking the whole leg apart to get the spring reattached inside. </div></div>

all you need to reassemble bipod legs is about 18" of dental floss tied in a loop.makes it really easy, takes maybe 45 seconds. that's your only hint for next time.

think about it.....

 

[jawa]

Re: Eagle Claw Bi-Pod

Thanks for the info guys... You too Phideaux, its makes me laugh that it was that easy.

 

[PDXGS]

Re: Eagle Claw Bi-Pod

Phoenix Tactical sold by Triad