F/S CZ457 Precision Trainer, Manner Carbon Fiber, Area 419 goodies

[POGPride]

CZ457 precision trainer with lilja .900 full bull barrel match stainless steal 16.5" 1:16 twist, threaded 1/2-28. This has the new Lilja design "Lilja 2" chamber. (See their website for details.
DIP mag well
DIP extended mag release
419 Bolt knob
419 scope base
419 ARCA rail
Manner Carbon Fiber Elite tactical
Victor Co. Cheek Riser
2 10 Rd mags with BLAMM extensions (12 RDS)
1 25 Rd mag with awesome banana stickers
Plano Gun case

I have the original 24" barrel

Bipod, suppressor, stock pack and scope not included

The gun is incredibly accurate with Eley and Lapua ammo. These are really impossible to find especially with the manners stock. Gun has less than 1000 RDS on it and I spend about $2800 putting it a together. My loss, your gain.... Especially if you have been looking for one.

$2,200 shipped CONUS. FF or you pay fees.

 

[Ikyo]

How much difference did you notice with the new barrel?

 

[POGPride]

How much difference did you notice with the new barrel?

It was significant. Some group improvement, but most of what I noticed was in the consistency. The original barrel would throw an occasional shot, the Lilja puts them in the same spot every time.

 

[Ikyo]

I was thinking about getting a longer barrel for mine. It was between getting a longer factory or an aftermarket barrel.

 

[POGPride]

I was thinking about getting a longer barrel for mine. It was between getting a longer factory or an aftermarket barrel.

Shorter is better with 22LR. After 16/18 inches the bullet is slowing down.

 

[Ikyo]

Okay, so an aftermarket 18" would be the best option then.

 

[POGPride]

I would go 16".5... Sort of like I did??. Check out Lilja ... Give them a call... They did science and science says 16.5 is bestest....

 

[Ikyo]

Okay, the only drawback to the 16.5 barrel is the chassis I am putting it into.

 

[POGPride]

Okay, the only drawback to the 16.5 barrel is the chassis I am putting it into.

You are kind hi-jacking my thread here bro... That is sort of bad manners... Not trying to be a dick but we should be discussing this in the CZ457 thread in the rimfire section... But It's all good... What Chassis? Is MDT doing an ACC for the 457? That might not look too nice... MPA will have a hybrid for the 457 out soon.