Fastest Turn-Around Time on Remage Barrels?

[LongRangeJunky]

Debating hard on sending my action out to be fitted by my gunsmith or going the Remage out. Gunsmith has quoted me 2 weeks (you can guess who that is!) Cannot seem to find any Remage options with less than 6-8 weeks turn around to get the barrel in my hand. If I could have either in the same amount of time I'd probably go Remage, but if its going to take weeks or months I'll just send it out to be fitted properly.
If you know of any quality Remage makers out there that I am apparently overlooking please let me know!

 

[Steel head]

Northland shooters supply might have CBI and Shilen barrels in stock for remage if those are good enough for you.

 

[Badfinger]

You didn't say what caliber you were looking for. I received a .308 remage kit from McRee two days after placing the order and I'm in Ohio. Might want to give Scott a call.

PHONE 662-453-0022, EMAIL [email protected]

752 CR 174, McCarley, MS. 38943

 

[LongRangeJunky]

Thanks guys. I spoke with NSS today. I am looking for a 24" threaded 30-06 Varmint Contour. They only had 26" non threaded 30-06 tubes ready to go. If I am going Remage then I want it pre-threaded and 24". The wait would be way too long through them.
Mcree looks good except they only have 24" threaded .308 barrels ready to go... I might actually do this then get a 30-06 tube later on.
Tough decision!

 

[LRI]

I could have this done for you in 96 hours. Fitted to the action, not assembled with a "Jebus nut."

 

[armada]

http://www.snipershide.com/shooting...iper-s-hide-bolt-action-rifles/6258676-bugnut


Did you check out the Bug Nut.