Hello
Got my forster co-ax press on the mail yesterday and like a kid with a new toy , rigorously opened the box and started to play with it.
Ran some neck dies and full size also with redding and forster dies on winchester brass 6.5/55 SE , neck concentricity a outstanding .001 .
But when I seated the bullets the RUN OUT went to .005 ( RCBS SEATING die standard )
I'm wondering if I'm doing something wrong , I notice when I install the die and you know doing the way of putting a resized case you are suppose to screw the die until there is resistance on the shoulder but the die will touch the bottom of the sliding shell holder before I fell any resistance ,
I wonder if the die does not go far enough to were it can line the bullet on the neck
Best regard.
Got my forster co-ax press on the mail yesterday and like a kid with a new toy , rigorously opened the box and started to play with it.
Ran some neck dies and full size also with redding and forster dies on winchester brass 6.5/55 SE , neck concentricity a outstanding .001 .
But when I seated the bullets the RUN OUT went to .005 ( RCBS SEATING die standard )
I'm wondering if I'm doing something wrong , I notice when I install the die and you know doing the way of putting a resized case you are suppose to screw the die until there is resistance on the shoulder but the die will touch the bottom of the sliding shell holder before I fell any resistance ,
I wonder if the die does not go far enough to were it can line the bullet on the neck
Best regard.