Gunsmithing Gunsmiths that do Remage barrels?
- Thread starter wes1
- Start date
Is the barrel contoured to accept a barrel nut? If it isn't then a CF wrapped blank is not something that can typically be recontoured except by the manufacturer and even then they may decline it.
We can do it for an Origin either way. I cut a bunch of Origin prefits this week and more next week.
The Origin doesn't use Remage barrels.
We can do it for an Origin either way. I cut a bunch of Origin prefits this week and more next week.
The Origin doesn't use Remage barrels.
it is more than likely built up for a typical 1.2 to 1.25 should and can't be turned down to the 1 1/16 diameter for a remage setup without destroying it..
a remage barrel can be no thicker than the major of the barrel thread.
if it were me I would sell it and buy a CF barrel that was mfg specifically to be a remage several top tier makers of CF barrels make them I believe.. proof and carbon six come to mind
a remage barrel can be no thicker than the major of the barrel thread.
if it were me I would sell it and buy a CF barrel that was mfg specifically to be a remage several top tier makers of CF barrels make them I believe.. proof and carbon six come to mind
Use a Barloc from American Rifle company for a barrel with a shoulder. PVA works with ARC, so they could chamber and thread it for the shouldered Barloc. Easiest way to make it a switch barrel.
