Hello,
I am currently using a Redding Type S FL Sizing die on once fired 6.5-284 Lapua brass. I inserted a bushing, but for some strange reason I am unable to fully size the neck. If I size 3/4 of the neck, I am lucky. I adjusted the stem all the way to make contact with the bushing and then backed off about 1/32". This still didn't size the entire neck.
Equipment:
Redding Big Boss II
Redding Type S FL Die
Hornady Lock and Load Press Bushing
Hornady Lock and Load Conversion Kit
Any thoughts on this would be greatly appreciated.
I'll post pictures of the sized brass tomorrow.
Thanks.
I am currently using a Redding Type S FL Sizing die on once fired 6.5-284 Lapua brass. I inserted a bushing, but for some strange reason I am unable to fully size the neck. If I size 3/4 of the neck, I am lucky. I adjusted the stem all the way to make contact with the bushing and then backed off about 1/32". This still didn't size the entire neck.
Equipment:
Redding Big Boss II
Redding Type S FL Die
Hornady Lock and Load Press Bushing
Hornady Lock and Load Conversion Kit
Any thoughts on this would be greatly appreciated.
I'll post pictures of the sized brass tomorrow.
Thanks.
Last edited: