M
milo 2.0
Guest
Well I said I'd never neck turn, no matter what. But I'm getting the dreaded donut on the outside of my cases, didn't notice chambering problems till after seating a bullet.
So what brand do you guys like? I researched Sinclair's and 21st Century, have their lathe in my shoppinig cart right now, pricey but looks qaulity. Give me some insight please.
Ok, my donut is on the outside only, near as I can tell, but what would one use if it was on the inside? I haven't found anything for that yet.
My donut is small, right at the begining of the neck, would a reg FL die knock it back? I'm using bushing dies with over reamed necks.
So what brand do you guys like? I researched Sinclair's and 21st Century, have their lathe in my shoppinig cart right now, pricey but looks qaulity. Give me some insight please.
Ok, my donut is on the outside only, near as I can tell, but what would one use if it was on the inside? I haven't found anything for that yet.
My donut is small, right at the begining of the neck, would a reg FL die knock it back? I'm using bushing dies with over reamed necks.