I got a Lobos industries trigger and am following the very detailed instructions with photos from HK Pro to remove stock trigger. Have seen the YouTube videos as well.
I ran into a roadblock trying to remove the trigger stop pin. It WILL NOT BUDGE! The directions say to just push it out with a punch, but you have to get the punch in sideways in a lever/prying angle, rather than directly on it. Says it is supposed to pop out easily. Some say to tap it from outside in other direction to loosen loctite from factory...still no dice.
I am prying/pushing so hard I'm bending my punches and it isn't moving at all. I stopped cuz something is obviously wrong here.
Any ideas or help?
I ran into a roadblock trying to remove the trigger stop pin. It WILL NOT BUDGE! The directions say to just push it out with a punch, but you have to get the punch in sideways in a lever/prying angle, rather than directly on it. Says it is supposed to pop out easily. Some say to tap it from outside in other direction to loosen loctite from factory...still no dice.
I am prying/pushing so hard I'm bending my punches and it isn't moving at all. I stopped cuz something is obviously wrong here.
Any ideas or help?
