So i am a noob with the precision stuff. I have gone from 3 shot groups to 5 shot groups. How bad am i?
How bad are my groups?
- Thread starter Aimatdeer
- Start date
Measure the widest diameter of the group. Then measure the mark left when the bullet went through the target- you will note this mark is smaller than the bullet diameter. Subtract the mark diameter from the group diameter. Divide by 1.047 inches per MOA per 100 yards. This will give you the group size in MOA. Anything less than 1 MOA is generally considered good. Less than 0.5 is really good. Yours look to be at or just below 1 MOA. If you are just getting started, I'd say you are off to a good start.
Don’t forget to use the dime to cover any flyers. ?
If you were always trying to hit the dime, you're kind of awful.
You’re shooting from way too far away. If you’re going to post three or five shot groups on the internet you need to shoot from just beyond where the muzzle blast tears the paper.
Either that or just shoot once and call it a five shot group....
Either that or just shoot once and call it a five shot group....
