Just built an annealing machine with internet instructions. How do i judge when the brass is annealed properly?
How to set up annealing machine
- Thread starter Forward543
- Start date
Start here then ask questions on what you might not understand. It's the first post/sticky in this forum..
http://www.snipershide.com/shooting/forum/s...nnealing-guide
http://www.snipershide.com/shooting/forum/s...nnealing-guide
Last edited:
I just bought an annealer from cartridgeannealing.com. Go on there and watch his instruction video.
I apply 750 degree Tempilaq inside the neck of cases. When it turns, the brass is annealed. Damage to the brass occurs above 900 degrees, so I get it out of the heat as soon as the Tempilaq turns with a reasonable safety margin.
I use a Giraud annealer. I paint up 20 or so cases, use the first few to get the cycle time set, then inject the remaining cases periodically into the run to verify that the process is not drifting.
I use a Giraud annealer. I paint up 20 or so cases, use the first few to get the cycle time set, then inject the remaining cases periodically into the run to verify that the process is not drifting.
