Impact action in a KRG Whisky 3- help please

[elmuzzlebreak]

Has anyone used an impact action in a krg whisky 3 and if so how did you accommodate the trigger hanger?

 

[McMillan]

Mine is in a whiskey 3. I had the stock milled out to clear the trigger hanger and opened up around the bolt handle

 

[elmuzzlebreak]

Thanks for the reply. About how much material had to be removed?

 

[McMillan]

I can't remember confidently enough to state a figure. If no one else chimes in I can measure it tomorrow

 

[elmuzzlebreak]

I can't remember confidently enough to state a figure. If no one else chimes in I can measure it tomorrow

Sounds good I’d appreciate it. I am seriously debating going to a whisky 3 from my MPA but concerned about the inletting.

 

[spife7980]

KRG impact action mod

Im sure it's been covered in threads but after a ton of research I couldnt find a thread that covered WHAT exactly to file away. Hopefully this helps those who are going to run the krg impact action combo. This little ridge around the screw is what needed to be reduced. As well as a low...

www.snipershide.com