Is a 5/32 drill bit okay for 10-32 x 3/16 knurled set screws?

[URGILOVERR]

I have an Slr jig that can’t fit anything bigger than a 5/32 drill bit is this okay for the BCM gas block that uses 10-32 x 3/16 knurled set screws?

 

[LeftyJason]

I have an Slr jig that can’t fit anything bigger than a 5/32 drill bit is this okay for the BCM gas block that uses 10-32 x 3/16 knurled set screws?

Might be good to watch the video on slr site.

Far as I can tell it is a dimpling jig. Shallow. As in just the pointy part of the drill. End result should look like this. No actual hole. No verticle sides to the dimple.

 

[supercorndogs]

Or just don't dimple it. Its not hard to line up with out one.

 

[RumT]

5/32 drill bit size is the tightest tolerance size for 10-32. If you have a heavily coated fastener, a Friday fastener......... it may get tight. If you have a cheap fastener it may snap. #21 isn't hard to find out in town. I'd use 5/32 for aerospace level stuff with aerospace level fasteners if directed by spec. I'm not sure I'd trust a non sourced fastener for this.