Suppressors is there a concensus answer: do sig taper lok mounts fit all barrels or not?

[Winny94]

Seems ridiculous that there is so much confusion and lack of clarity, but here we are. So has a concensus been reached in regards to Sigs Taper Lok Mounts fitting all barrels?

 

[smokin.338]

What confusion and lack of clarity, do you speak of ??

 

[Winny94]

What confusion and lack of clarity, do you speak of ??

At some point (maybe it was first batch, maybe it was wrong models being sent out) the mount itself was also tapered on the inside, which led to engagement of only a couple of threads before the taper contacted the 90 degree shoulder of the barrel.

 

[Eben]

It probably hasn't had a revision, as it's designed to both attach to a Sig tapered and to other non tapered barrels.
I can't find a dimensional drawing, maybe someone can measure how far up the threads start, so we could compare against our non Sig barrels to determine if there are enough threads.

 

[A5scott]

I have a Sig SRD556 direct thread and it snugs up nicely on a pair of my ARs... Colt 6933 and an LWRC IC-A5 that I threaded it onto.

Scott

 

[smokin.338]

Gotcha... looking at it from Sig, the design hasn't changed any. But do see where there may be a problem if said barrel (i.e. bull barrel) was a thick diameter and/or threads were threaded short though.


[video=youtube;-KRq2SHeoj0]https://www.youtube.com/watch?v=-KRq2SHeoj0[/video]