Is a spuhr with 6mil mounted on a rail with 20moa built in, to much for a Kahles 624? can't get mine to zero at 100 yds. Am i doing something wrong?
Rifle Scopes Kahles
- Thread starter jinxx4ever
- Start date
20 moa mount on a 20 moa rail WILL cause your issue.
so you need to ditch one of the 20moa, or zero further out
so you need to ditch one of the 20moa, or zero further out
it's on a mpa chassis, and the other spurh i have , mounts it way high off the barrel. Guess it's ordering another spuhr with lower heigth
The Kahles 624 has 26 mils of total elevation adjustment, correct? You should be able to zero at 100 yards with a rail/mount combo of 40 moa. Should be at or near the bottom end, but should still be able to get a zero.
It would be damn close (my very rough estimate would be 1.3 MILs up from where you need to be). Some erectors have extra range in them, some don't. The specs sheet won't specify this generally.
Like Bkultra stated - check your zero stop and make sure it's not creating an artificial stop when you truly still have more downward erector travel remaining. Worst case, get a 0 MOA (you would probably be ok with a 10MOA if you wanted to risk it).
Like Bkultra stated - check your zero stop and make sure it's not creating an artificial stop when you truly still have more downward erector travel remaining. Worst case, get a 0 MOA (you would probably be ok with a 10MOA if you wanted to risk it).
As long as you don't really crank on it. If the zero stop is "disengaged" and you go down as far as you can gently then that's all you can do. Logically, no forcing anything.
I had tried a 20 MOA Rail and 9mil/~30 MOA Spuhr and could not zero at 100 yards. I was 1.5 mils high at 100. Should be ok with 40MOA total. Have a 6mil Spuhr I am going to try next.
I just took my 525 with a 4601 and Defiance Deviant w/20MOA and was able to sight in at 100. I had 26.4mils of useable travel which on my 6mm gets me out to 2100+ yards as of yesterday. I have not decided if I will keep it or go back to a 0MOA.
How much total travel do you have when it’s bottomed out when you are attempting to zero?
If it’s much less than what the total travel I’m the optic is supposed to be, then you need to adjust turret to different zero stop, or there is something wrong with the internals.
Also, unless you really need the extra 5.8 or so mil, no need to run 40 moa and have the erector need one end.
