A quick question regarding disassembled bullets.
I just used a kinetic hammer to remove the bullet/powder from a few bullets that I intend to load again.
In some of the rounds it looks like some yellow powder has been released from the primer (Using Fed210 match primers) after the bullet had been disassembled.
Its not visible in all of them, only a handfull.
So my question is, can I load the cases again with the primers still installed? (after neck sizing them without the depriming pin ofcourse)
I dont like depriming the case if I dont have to with a live primer in it
Best!
ikalli
I just used a kinetic hammer to remove the bullet/powder from a few bullets that I intend to load again.
In some of the rounds it looks like some yellow powder has been released from the primer (Using Fed210 match primers) after the bullet had been disassembled.
Its not visible in all of them, only a handfull.
So my question is, can I load the cases again with the primers still installed? (after neck sizing them without the depriming pin ofcourse)
I dont like depriming the case if I dont have to with a live primer in it

Best!
ikalli