KRG Bravo Feeding issues

[nexusfire]

I have a Bravo stock that is paired up with an ARC Nucleus in long action. I am using Accurate 300WM mags in CIP length. The bolt is riding over the round unless I push on the bottom of the mag.

Anyone else run into these issues?

 

[alfmoonspace]

You can adjust the trigger guard forward and aft as well as the front hand guard to slide the mag up into the catch better. See if that helps? Have the same set up and I had to play with it a bit to get it to seat right.

 

[nexusfire]

I will give that a try

 

[ThreeBravo]

I have a bravo in 6.5cm and had the same issue, opened up the feed lips a little and played with the trigger guard like @alfmoonspace recommended and it fixed my feeding issues.

 

[rugby10]

I had the same issue with a KRG X-Ray and AICS compatible mags.

 

[2aBaC̶a̶]

I have the exact same setup and there are instances where it wont insert fully unless a firm push is applied.

 

[nexusfire]

I have the exact same setup and there are instances where it wont insert fully unless a firm push is applied.

What did you end up doing? I don't believe its a problem with the mag. Accurate makes great mags. It has to do with the mag catch in my opinion.

 

[EN2722]

I also had the same problem just with a SA. I contacted KRG and they fired an email right back with the solution.

As @alfmoonspace said. I was not familiar with which screw was used to adjust the trigger guard. The picture below is from KRG.

 

[nexusfire]

^thanks man ill give that a try.

 

[2aBaC̶a̶]

What did you end up doing? I don't believe its a problem with the mag. Accurate makes great mags. It has to do with the mag catch in my opinion.

Nothing, I just make sure to push the mag in with authority.

I will try that screw though.