Labradar issues

[yeff]

Has any one had any issues with Labradar and shooting with muzzle brake? When I first got it I had no issues but twice now when I have gone to use it with muzzlebrake on after one or two shots it goes into unarmed mode. I rearm it and get one shot and back into unarmed mode. This has happened to me twice and not sure if I need to send it in for service. This is with 6.5 creedmoor and area 419 brake.

Thanks.

 

[dave300]

Call them, pretty quick to help over the phone. But no relatable issues with my unit. GL

 

[waveslayer]

I would give them a call, but out of curiosity, where are you placing the labradar when you are using a Break? I ask because I was told by Labradar to place it right next to my scope, the Labradar will trigger with a break from that distance.

 

[German_Hunter]

Hi,

I´ve had the same issue. It was not because of Shot, but because of SD-Card. It would not write on SD-Card. Try a different SD-Card or try without.

Manuel

 

[yeff]

I have had the labradar back about 12" from brake. I will also check out the SD card and see if that fixes it. Thanks for the responses!

 

[SmokyJoe]

Also, if you are on the line with other Labradars running, make sure you are not on the same channel. For 6.5 CM I set the brake 9” to the side and 9-12” in front the unit. In settings I select a 12” projectile offset and trigger level of 6. This consistently works for me. Make sure you have it pointed at the target. The notch alone is not really useful for good alignment. I put a 6” length of 3/8” dia round bar stock in the notch to make it easier to get it pointed at the target.

 

[mrtoyz]

Yes call. They even answered on a Sunday!!??