Round 3 in my ladder testing. 300WM 230 Hybrid Target. H-1000
Prior 2 ladder tests showed 2 nodes. One around 2900 fps, and a lower one at around 2800 fps. The upper node was inconsistent but the lower one is almost too consistent.
My thought is to proceed with seating depth using #4 (73.6gr) But there is a lot of room there to work with and this test was .1gr increments. My thought was due to the temp being in the mid 30's. That would leave a pretty wide margin for higher temps.
My question to you all. Where would you go from here?
Conditions were 35*F/28.51" Station press./76% RH Range 550 yds.
Yes shot #1 was very low on the paper so I moved it up 1 moa. The plotted spot should be accurate. would have liked to shoot this test at a longer range but it snowed up there last night so accessing the longer range was going to be problematic...
Prior 2 ladder tests showed 2 nodes. One around 2900 fps, and a lower one at around 2800 fps. The upper node was inconsistent but the lower one is almost too consistent.
My thought is to proceed with seating depth using #4 (73.6gr) But there is a lot of room there to work with and this test was .1gr increments. My thought was due to the temp being in the mid 30's. That would leave a pretty wide margin for higher temps.
My question to you all. Where would you go from here?
Conditions were 35*F/28.51" Station press./76% RH Range 550 yds.
Yes shot #1 was very low on the paper so I moved it up 1 moa. The plotted spot should be accurate. would have liked to shoot this test at a longer range but it snowed up there last night so accessing the longer range was going to be problematic...