Good Morning,
I was looking to load up some plinking rounds for my wife's ar this weekend. I am going to be using some varget powder, I have the hornady reloading book 7th edtion to get my powder rates from. I am mainly looking for info on case size and oal of the loaded round. Is that as important for a plinking around as a bolt gun?
I have a fl sizer die and seater. If most of the brass was previously shot out of her gun should I need to re-size it the first time I reload it or just check the case length and trim it if needed and reload away. I am not looking for long distance accuracy atm mostly just a little Sunday afternoon shooting fun.
Thanks for any info and tips. I am just now starting to cut my teeth and don't want to over process my brass if I don't need too since I don't have an annealing setup yet.
I was looking to load up some plinking rounds for my wife's ar this weekend. I am going to be using some varget powder, I have the hornady reloading book 7th edtion to get my powder rates from. I am mainly looking for info on case size and oal of the loaded round. Is that as important for a plinking around as a bolt gun?
I have a fl sizer die and seater. If most of the brass was previously shot out of her gun should I need to re-size it the first time I reload it or just check the case length and trim it if needed and reload away. I am not looking for long distance accuracy atm mostly just a little Sunday afternoon shooting fun.
Thanks for any info and tips. I am just now starting to cut my teeth and don't want to over process my brass if I don't need too since I don't have an annealing setup yet.