Gunsmithing Looking for a gunsmith in Wi to rework XR100 Rem

[scsbronco]

Where can I get a XR100 Remington in .204 machined or reworked?

The bolt face was embedded with brass after a shot was fired after a reload with no powder. The two bullets made it out of the barrel but the face and extractor properties are lacking now. Also the firing pin hole is not uniform.

How do I know if the barrel will be fine?

I found company that makes a replacement bolt PTG. Is there anyone you guys can recommend to rework the gun?



HELP PLEASE

 

[Jkob]

Re: Looking for a gunsmith in Wi to replace bolt on XR

You may have a bulged barrel. What damage is done to the bolt "Could" be repaired but would not know until it is evaluated. I may have a used bolt that might fit. Email me if interested. Where are you located?

 

[308saiga]

Re: Looking for a gunsmith in Wi to replace bolt on XR

PICS??? Hard to believe that one could cause this much damage with primers.....

 

[scsbronco]

Re: Looking for a gunsmith in Wi to replace bolt on XR

It was cause by Bullet "a" with no powder firing the bullet out of the case but probably not out of the barrel.... then Bullet "b" fired after

 

[rubicon_unlimited]

Re: Looking for a gunsmith in Wi to replace bolt on XR

check out centershotrifles.com Jim is located in Pittsville!