Modding stock and forend to DPMS LR-308?

[Wannashootit]

Stock-
Adding the Magpul PRS, compatible with the standard factory A2 buffer tube?

Also want to add a new handguard, perhaps the Troy TRX, but factory measures 12-1/2" and the TRX comes in 12" length.

It's the 24" bull barrel model- what will be most compatible with the factory railed gas block (or am I going to need to change it out?) and matching the height of the existing receiver's full-length top rail?

Seeking suggestions?

 

[ORD]

PRS is a direct swap on rifles with standard rifle-length/A1/A2 tubes (minus the spacer on the A2). Unscrew the stock bolt, pull off the A2 body and spacer, slide the PRS on, install the Magpul-supplied, vented stock bolt. DONE!

The factory-length for the DPMS pattern, rifle-length gas systems is ~12.5", but the TRX 308 rail in the "12" configuration is actually ~12.6" long. They will meet up to (closely, but not touching), the gas block/journal area. If you want a longer rail, you'll need to look at the 13.8 and swap to a low-profile gas block. Do be sure that whatever TRX you order, you match the receiver height of your existing DPMS upper (both "low" and "high" profiles are available...measure twice...order once!! ).

 

[Wannashootit]

Thank you!