MPA Data Card holder new style?

[Beef1911]

I just got a second hand (never used) MPA BA chassis and it came with a data card holder and a 2 round holder. The packing list says it was shipped in December of 2021.

It came with no instructions and the videos and pictures on MPA's website are not what I have.

It seems like it plugs 2 of the oblong holes, and the one plug should stick through, turn 90 degrees and clamp down, but it doesn't get tight. Just flops around. I must be doing it wrong.

Anybody know how this style is supposed to work?

 

[inertia]

I just did mine, I'm not trying to be a jerk but not sure how to get it wrong, it works like an mlok. You can hold the nut in place with a finger while you snug it down. I did remove the card holder section and tap that front lug in first.

 

[Beef1911]

I just did mine, I'm not trying to be a jerk but not sure how to get it wrong, it works like an mlok. You can hold the nut in place with a finger while you snug it down. I did remove the card holder section and tap that front lug in first.

At the risk of making myself look like a bigger idiot, does this look like right to you? Seems like there's not enough thickness on the magwell before the T-nut bottoms out.

 

[justwoody1]

At the risk of making myself look like a bigger idiot, does this look like right to you? Seems like there's not enough thickness on the magwell before the T-nut bottoms out.


View attachment 7810991

You got the wrong two round holder and data card holder for that chassis. The mag well is slimer on that chassis.
Send me an email [email protected]

 

[PinesAndProjectiles]

And kudos to MPA for perusing the forum to give a helping hand. Well done, sir!!